CONGRATULATIONS ON HAVING CHOSEN A
FERPLAST PUMP.
All Ferplast pumps (BLUPOWER
and SMART) are completely submersible and have
been designed to ensure total respect for the
health of the fish and plants in your aquarium, with
the utmost simplicity of use and in absolute safety.
Every pump has been designed, built, checked and
inspected in accordance with the
EN 60335-2-41
international standard.
INTRODUCTION
• Ensure that the voltage shown on the appliance
corresponds to that of your home electrical power
supply.
• Disconnect the appliance from the power supply
before carrying out any maintenance work.
• The power supply cable cannot be repaired or
replaced: if damaged, the whole appliance must be
replaced.
• The temperature of the liquid must not exceed
35° C.
• The maximum depth of immersion is 1 m.
• This appliance is for internal use.
• Ensure that your home is protected by an automatic
breaker switch with an operating current of no
more than 30 mA.
• When connecting the heater to the power supply,
ensure that the lowest point of the cable is lower
than the electrical socket so that any drops of water
do not accidentally run down the cable and into the
power supply.
• This product should not be used by unsupervised
children or unfit persons.
MAINTENANCE: important
• Always disconnect the plug from the power supply
before removing the pump from the water or
carrying out any maintenance.
• Clean the intake grilles regularly, checking that
they are not blocked.
• Clean the pump rotor every 3-4 months.
1 Remove the cover (on the BLUPOWER 900-1200 it
is necessary to press the button on the top of the
pump – see figure
A
);
2 Take out the rotor and clean it with a soft brush and
warm water (DO NOT use detergents or abrasives).
3 Reassemble the pump.
•
•
T
IT
PL
RU
DA
SV
HU
CS
SK
ES
NL
D
FR
EN
BLUPOWER & SMART
363009-4_FI_Blupower_Smart.indd 8
363009-4_FI_Blupower_Smart.indd 8
24/02/11 12.19
24/02/11 12.19
Cyan quadricromiaMagenta quadricromiaGiallo quadricromiaNero quadricromiaPANTONE 648 C
