EN
ASSEMBLY INSTRUCTIONS
1.
Choose a location which will receive as much as possible sunlight for your solar shower.
2.
Mount the lower stand with shower base(
B
) to concrete slab or wood base with four bolts,
washers and nuts(
K
). We recommend using wrench.
3.
Attach shower head(
D
) with gasket(
G
) and gasket(
F
) to the extension pipe(
E
). Attach the
extension pipe(
E
) with gasket(
F
) into the thread of the upper stand (
A
). Adjust this parts only with
your hands. Do not use a wrench.
4.
Put the O-ring(
C
) onto the lower stand(
B
).
5.
Lift the upper stand (
A
) onto the lower stand (
B
). Connect the hoses.
6.
Turn the locking ring clockwise to connect the two stands (
A+B
). Handle and shower head (
D
)
need to face the same direction.
7.
Attach footwash(
H
) with gasket(
F
) to the lower stand(
B
).
INITIAL SET UP OF THE SOLAR SHOWER
1.
Open the handle and turn it to position “hot”. This ensures that no air pockets are trapped in the
hoses while filling with water.
2.
Attach your garden hose to the hose connector(
J
). Turn on the water to fill the solar shower. It
will take some minutes to fill up the solar shower.
3.
When the water flows out of the shower head (
D
), turn the handle off. Now the solar shower
begins to heat the water.
4.
Depending on available sunlight and outside temperature, the solar shower will take about two
hours to fully heat the water.
5.
Water temperature in the solar shower can reach up to 60 degrees during strong sunshine.
WARNING:
To avoid scald,pay attention to turn the handle to “cold” water position before using the
solar shower. Then adjust the desired temperature.
WINTERIZATION
1.
Turn off and disconnect the garden hose.
2.
Open the handle and turn it to position “hot” to allow the water to drain out of the hoses and solar
shower( This takes app. 8-10 minutes). Do not turn off or turn the handle while draining, otherwise
the water will stop draining out.
3.
Turn the locking ring counter- clockwise to unthread the upper stand (
A
) from the lower stand(
B
).
After this, please disconnect the hose connection. Now the water can run out of the solar shower.
4.
Disassemble the lower stand (
B
) and pour the remaining water out of the solar shower.
5.
Clean and dry all solar shower parts.
6.
Store all solar shower parts indoors and in a dry place during winter season to prevent frostbite.
ATTENTION
- Do not use salt or other anti freezing methods.
- Recommended water pressure: maximum 3,5 bars.
- The heating of the water results an expansion of the water. This allows the water to escape
minimally out of the shower head.
- When initial use the shower in order to rid of plastic and oil smell, please let water run out for
several minutes and clean the shower inner parts with flowing water.
SERVIS
Središnji ovlašteni servis:
Fero-Term d.o.o.
Gospodarska ulica 17,
10255 Donji Stupnik
Servis Dalmacija
Zadar
, Ulica 84. Gardijske Bojne HV
Termiti 41
Split
, Stobrečka 5
Za Sloveniju:
Fero-Term
Kajuhova 32T,
1000 Ljubljana
Servis Istra i Kvarner
Rijeka, Kukuljanovo 363
Servis Slavonija
Osijek, Gundulićeva 33
