3
© Ferno-Washington, Inc 234-3488-00 April 2012
Side Extension Panel 069-5796 and 000SEPKIT
1. Place the SEP on a surface bottom side up (Figure 1).
Figure 1 - Place SEP Bottom Side Up
Figure 2 - Attach a Support Arm Assembly to the SEP
Align the Pin
With the Hole
Press Down
Latch
Figure 3 - Attach the SEP to the Embalming Table
Figure 4 - Verify the Rubber Stopper is Firmly Resting
Against the Bottom of the Embalming Table
1 - ASSemble AnD AttAch the SeP
2. Align the spring-loaded pin in the Support Arm
Assembly with the hole in the SEP (Figure 2).
3. To release the latch, pull the ring, and then press the
latch down.
4. While applying downward pressure, press the latch on
the Support Arm Assembly down to snap the Support
Arm Assembly into place (Figure 2).
5. Once snapped in, pull upwards on the Support Arm
Assembly to verify that it locked into place.
6. Repeat steps 2-5 on the opposite end of the SEP.
7. To attach the SEP assembly to the embalming table,
simultaneously press each metal latch lock while
sliding the Support Arm Assembly onto the embalming
table (Figure 3).
Hole
Hole
Metal Latch
Lock
8. Verify that both rubber stoppers of each support arm
assembly are firmly resting against the bottom of the
embalming table.
Pull the Ring
