© Ferno-Washington, Inc. / 234-3622-06 / March 2019
23
16
14
15
4.17 Position Indicator Lights
The position indicator lights (Figure 16) project a red line
on the ambulance floor as a visual aid for the operators. The
lights have no effect on iN∫X operation.
The position indicator lights are activated during the loading
and unloading processes to help the operators visually
locate the proper position to stop rolling the iN∫X and extend
or retract the control-end legs.
The red line shows the approximate position of the
intermediate loading wheels. If the line is visible on the
ambulance floor, then the intermediate loading wheels and
the majority of the load (the weight on the iN
∫
X) are also
inside the ambulance.
Features and Controls
4.15 Mode-Select Button
The mode-select button is located on the left side of the
display (Figure 14) and allows the user to cycle between
three direct power modes and the set-loading height
feature. Direct power modes are rarely used. See “Direct
Power Modes” on page 42.
Each button press cycles to the next mode, with matching
images on the display. The button-press sequence is:
●
Direct power both legs
●
Direct power loading-end legs only
●
Direct power control-end legs only
●
Loading-height set mode. See “Set the Loading Height”
●
Standard operating mode
4.16 Telescoping Handles
The telescoping handles lock in two positions: fully retracted
and extended (about 9 in/225 mm). Use the telescoping
handles only when they are in a locked position.
To change the handle position:
1. Press the red button on the end of the handle (Figure
15), then push or pull the handle to the desired
position.
2. Release the button. Push or pull the handle to verify it
has locked.
Position Indicator Light
(Each Side)
Mode-Select Button
Press Button to Extend or
Retract the Handle