AdvantagePro Instructions: ID# 00152-V1- 08/2012
2
FITTING INSTRUCTIONS
INSPECTION
7. Pass both leg straps between your legs making
sure there are no twists in the straps. NOTE:
Leg strap quick connect buckles are black
coloured. Connect the left leg strap’s Quick
Connect buckle to the left leg link, and the
right leg strap to the right leg link. Adjust both
for a comfortable fit.
Securing Quick Connect Buckles
To connect buckle, feed Male part into Female part of buckle
and listen for an audible click, ensuring the buckle is fastened
and secure.
Releasing Quick Connect Buckles
To release the buckle, simultaneously depress the tabs on
both sides of the female buckle and remove the male portion
of buckle.
MALE Buckle
Adjustment tail
FEMALE Buckle
Fitting the Harness
1. Read the instructions carefully and check the
harness labelling to ascertain that you have
the correct harness for the task.
2. Inspect the harness for signs of wear or
damage.
3. Hold up the harness by the rear D-ring and
untangle any straps that have twisted during
storage.
4. Separate the shoulder straps and familiarise
yourself with the layout of the harness.
Unhook the waist and leg buckles from their
respective links.
5. Put on the harness by passing your arms
through the shoulder straps as if putting on a
jacket. Adjust the shoulder buckles so that the
rear of the waist belt is level with your waist.
6. Connect the front fall arrest buckle by feeding
the quick connect buckle male tongue
through the front “O” ring closes to your body.
Clip to the female part of the red buckle and
adjust for a comfortable fit. Check that the
rear D-ring is positioned centrally on your
back between your shoulder blades. If the
positioning is not correct, remove the harness
and slide the D-ring along the straps into the
desired position, and repeat Step 5.
8. Tighten and adjust the shoulder straps. Re-
adjust the front fall arrest attachment strap
and leg buckles. The finished fitting should feel
snug but not restrict movement in any way.
9. Secure loose ends with keepers and check for
twists, misaligned webbing and disconnected
buckles.
EMPLOYER: It is your responsibility to ensure all users are instructed and trained in the correct use and maintenance of the equipment. Once equipment is
issued, it is assumed this has been completed.
USER: Only competent users should use this equipment. It is your responsibility to read and understand these instructions and be properly trained in the use
of this equipment. Always use equipment safely and properly. Check equipment before and after each use
GENERAL: This document contains general fitting instructions. Instructions are not all inclusive. Modifying the equipment can cause injury and damage and
will nullify any warranty and place full responsibility for any accident or injury on the equipment owner.
To maintain the safety and serviceability of this product, the
following inspections must be performed:
1. Operator Inspection
The operator shall inspect the product before and after
each use. Check for excessive wear or damage of all
webbing, thread, and metal components. Refer any signs of
deterioration to a competent person for a decision on the
safety and serviceability of the product.
WARNING: Harnesses and lanyard assemblies should be
destroyed or returned to the manufacturer for inspection if a
fall has been sustained.
