Fermax SKYLINE MDS 7460, Техническая книга

Страница: 14 / 58

Depending on the type of module/s detected during start-up, the Digitiser will only present the options relative to
the type of panel, according to the following table:
To exit the programming, repeatedly press the P button, from the GENERAL OPTIONS MENU until the display
turns off.
The reader will automatically exit programming mode after 120 seconds of inactivity.
PROGRAMMING
PARAMETER
CONFIGURATION
GENERAL
OPTION
DISPLAY
PROGRAMMING
DECODERS
ENABLE AND ASSIGN PIN
TO OPEN THE DOOR
ASSIGN A TELEPHONE
NUMBER TO A BUTTON
INVERSE
PROGRAMMING OF
BUTTONS
SEQUENTIAL
PROGRAMMING OF
BUTTONS
SEQUENTIAL
PROGRAMMING OF
TELEPHONES
RESET BUTTONS
NECESSARY
MODULES
OBSERVATIONS
Programming the panel's general parameters.
On panels with only buttons, you can not
program these parameters, but you can verify
the programming status.
Programming decoders (both for MDS and
VDS)
Assign a telephone number to a button for
direct calling
Assign a button to a specific telephone
(previously programmed).
Assign the buttons to telephones sequentially.
Assign/change the number of a specific
phone.
Set all panel buttons to the default settings
(with the number "0000").
Programming and activation of the PIN to
open the front entrance door.
In order to enter in the Digitiser's programming mode, press the P button until the first option on the GENERAL
OPTION'S MENU appears (Parameter Configuration).
Repeatedly press until reaching the desired option, according to the following diagram.
MAIN MENU
/
+
/
P
P
P P
P
P P
P
P