Pag 44
ENGLISH
Configuración de la Placa Direct.
The outdoor panel´s parameters can be programmed on the keypad.
For this you must enter in configuration mode via a programming access code after pressing
‘A’.
Programming Access code:
A + 4444
(default code).
If the code is correct, a confirmation tone sounds (beep-beep).
The parameters that can be configured are:
Position
Adjust Parameter
Values [default] Comment
01
Time activ. lock releases 01-99” [03]
Relay activation of lock releases from home or access control.
02
Time activ. exit button
00-99” [06]
Relay activation of lock releases from exit button (terminals
Bs
y
-
)
03
Panel type
0: Sub-Block
Configuration of panel type
[1]:
Block
2: General Entrance
04
Block Nº
00-99 [00]
Block number belonging to the panel
05
Sub-Block Nº
00-99 [00]
Sub-block number belonging to the panel
06
Panel Nº
0-9 [0]
Panel number
07
Door sensor time
000-250
Maximum time that the door is allowed to remain
[000] inactive
open once activated
08
Opening code
0000-9999
Opening code from the keyboard. The means of
[0000] inactive
entering the code: A + XXXX (4 digits)
09
Programming code
0000-9999
Code to access programming
[4444]
10
MASTER panel
[0]: No / 1: Yes
Activation of panel as master to programme home terminals
11
Caretaker Mode
[0]: No Reset
Reset to night mode by entering “1” in this position
1:
Reset
12
Monitor Volume
0-9 [5]
Adjust the volume of the panel monitor
13
RESET settings
[0]: No Reset
Return to default settings by entering a “1”
1: Reset
in this position
Configuration of settings
Introduce the two digits of its position, you will hear a beep and then you need to enter the desired value (1,
2, 3 or 4 digits, depending on the setting). If the value is correct you will hear a confirmation tone (beep-beep)
and the new value will have been saved. If it was incorrect you will hear the error sound (boop).
To leave the programming mode you need to press ‘A’ when introducing the position number of the
menu. It will also automatically exit after 60 seconds without the need to press any key, generating a
beep-beep tone.
Position
+
Possible values
Comment
01...14 (beep)
1, 2, 3 or 4 digits (beep-beep)
Digits depending on chosen setting
Examples
09 (beep)
1128 (beep-beep)
Change of programming code to 1128
01 (beep)
02 (beep-beep)
Change of lock release activation time to 2
seconds
