Ferm
07
14. If the battery pack is broken or can no longer be re-charged it must be properly disposed of.
15. Never throw the battery pack into water or a fire – it may explode.
Electrical safety
Warning! When using electric tools, basic safety precautions should always be followed to
reduce the risk of fire, electric shock and personal injury. Read all these instructions before
attempting to operate this product and save these instructions.
Always check that the voltage on the batterypack corresponds to the voltage on
the rating plate. Also check that your mains voltage corresponds to the input
voltage of the battery charger.
The machine is double insulated in accordance with EN60335; therefore no earth
wire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in the wall outlet.
Prior to mounting an accessory always remove the battery.
Inserting and removing the drillbits
Fig. B
In addition to bits the machine can also hold screw bits with a hexagonal shaft.
•
Loosen the chuck (7) by holding one section and turning the other.
•
Position the drill bit shaft in the take up of the chuck.
•
Fasten the chuck until the drill bit is tight.
•
Open the chuck again when you want to exchange the drill bit.
Inserting and removing of the battery
Fig. C
•
Make sure that the direction switch (1) is in middle position to prevent the machine from
switching on unexpectedly.
•
Place the accumulator (3) in the bottom of the machine, as shown in the diagram, until it
engages.
•
Before removing the accumulator, depress the release buttons (A) and then take the
accumulator out from the bottom of the machine
The drill must only be used with the forward / reverse switch fully enclosed
3. MOUNTING ACCESSORIES
UK
94
Ferm
Vi erklærer herved, udelukkende på eget ansvar, at dette produkt opfylder følgende
standarder eller standardiserede dokumenter
EN50260-1, EN50260-2-1, EN50260-2-2, EN55014-1, EN55014-2,
EN60335-1,EN60335-2-29, EN61000-3-2, EN61000-3-3
i henhold til følgende direktiver:
98/37EEC, 73/23/EEC, 89/336EEC
01-10-2005
ZWOLLE NL
W. Kamphof
Quality department
Det er vores hensigt til stadighed at forbedre vores produkter, og vi forbeholder os derfor til
enhver tid retten til at ændre produktspecifikationerne uden forudgående varsel.
Ferm BV, Lingenstraat 6, 8028 PM , Zwolle, Holland
CE
KONFORMITETSERKLÆRING (DK)
UK
D
NL
F
E
P
I
S
SF
N
DK