Ferm ETM1004, Инструкция по эксплуатации

Страница: 4 / 76

4
EN
Specific safety instructions
• Always assume that the tool contains
fasteners. Careless handling of the tacker can
result in unexpected firing of fasteners and
personal injury.
• Do not point the tool towards yourself or
anyone nearby. Unexpected triggering could
discharge the fastener causing an injury.
• Do not actuate the tool unless the tool is
placed firmly against the workpiece. If the
tool is not in contact with the workpiece, the
fastener may be deflected away from your
target.
• Disconnect the tool from the power source
when the fastener jams in the tool. While
removing a jammed fastener, the tacker may
be accidentally activated if it is plugged in.
• Do not use this tacker for fastening electrical
cables. It is not designed for electric cable
installation and may damage the insulation of
electric cables thereby causing electric shock
or fire hazards.
Before using the tacker
• Check the following points:
• Do the voltage of the engine and the engine
safe-guard, if any, correspond to the mains
voltage (appliances for a mains voltage of
220-240 V);
• Are the mains lead and the mains plug in
a good condition: solid, without any loose
ends or damage.
• Always wear eye protection when using the
tool.
• Maintain the tool with care.
• Check for misalignment or binding of moving
parts, breakage of parts, and any other
condition that may affect the tools operation. If
damaged, have the tool serviced before using.
• Check if the slide cartridge has been fastened
properly.
• Do not use the tool in a humid environment.
• Do not use the tool on materials containing
asbestos.
Using the tool
• Do not use the tool if the switch does not turn
it “ON” or “OFF”.
• Always hold the tool with two hands while
starting.
• Always keep the cord away from the moving
parts of the machine.
• Keep your hands away from the work piece.
• In the case of jamming by a nail or staple,
switch the machine off immediately and
remove the plug from the mains.
• Never aim the tool at people or animals.
• Use only staples or nails fit for this tool.
• Make sure not to damage any leads when
using the tool.
Electrical safety
When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class ll machine. Your machine is double
insulated; therefore no earthwire is
required.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
2
. When using a cable
reel always unwind the reel completely.
Remove all staples/nails from the
magazine after each use
3. USE
Application
Fig. 2
For this tool, use one of the following types
staples or nails:
• U Type 55: 8, 9, 10, 12, 13 14, 15, 16 mm
• T Type 48: 15-16 mm