6
Start up
Once the mains has been connected to the receiver, it will
take up to15 seconds to start up. If this is the first time
installation, a menu will automatically appear.
Press when prompted.
If this is not the first time, follow the steps below :-
Auto tune
Once the receiver has been connected to the aerial and
television, the receiver can now be tuned in.
1. Press on the handset to turn the receiver on.
2. Press .
3. Select
SETUP
with
▲
/
▼
and press .
4. Select
AUTO TUNE
with
▼
/
▲
and press .
5. Press to select
REPLACE EXISTING SERVICES
.
Now wait while the receiver searches for all the available
services, this may take a few minutes.
The receiver will place the services in numerical order.
6. Press or to exit the menu. Alternatively
see later in the guide how to sort your Service List.
As new services become available, upgrade the
SERVICE
LIST
by selecting the
ADD NEW SERVICES
option or, when
major changes occur, use
REPLACE EXISTING SERVICES
option.
Manual tune
This allows an advanced user to manually tune services.
1. Select
MANUAL TUNE
from the
SETUP
menu and
press .
2. Now enter the channel number to be tuned.
This menu also shows the aerial signal strength. The Level
bar shows
GREEN
for good,
YELLOW
for poor, or
RED
for
bad signals. The higher the Bit Error number, the better the
signal is.
By changing
AUTO MODE
to
NO
, it is possible to change
other reception parameters.
TUNING THE RECEIVER
●
Back
●
Quit
●
Back
●
Quit
●
Back
●
Quit
●
Back
●
Quit
8510 FDT2000 Rev2 inc scart 17/2/03 6:27 pm Page 6
