50
Always check that the power supply
corresponds to the voltage on the
rating plate.
Your machine is double insulated;
therefore no earthwire is required.
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It
is dangerous to insert the plug of a loose cable
in the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The mini-
mum conductor size is 1.5 mm
2
. When using a
cable reel always unwind the reel completely.
6. ASSEMBLY
Prior to mounting an accessory always
unplug the tool.
6.1 Assembling the hand grip (Fig. 1)
The hand grip is suitable for either left or right-
handed use.
• Turn the hand grip (3) to the notch on the
right side of the machine for left-handed use.
• Turn the hand grip (3) to the notch on the left
side of the machine for right-handed use.
• Turn the hand grip to the notch on the top of
the machine to use it vertically.
6.2 Disassembly
• Remove the flange nut and the grinding disc
with lower flange from the spindle.
• Unscrew the 4 screws (with washers) en
remove the fixing-ring.
• Remove the guard from the machine.
6.3 Mounting a grinding disc (Fig. 2)
+
11
12
7
9
6
5
Fig. 2
Use grinding discs of the correct dimension.
Use fibre reinforced grinding discs only.
The grinding disc must not touch the edge of
the guard.
• Press the spindle lock (6) and turn the spindle
(9) until it engages in the lock. Keep the
spindle lock pressed during this procedure.
• Remove the flange nut (12) from the spindle
using the spanner(11).
• Position the grinding disc (7) on the flange
(5).
• Place the flange nut on the spindle an tighten
it using the spanner.
• Release the spindle lock and check that the
spindle is unlocked by rotating it.