The piping must be properly flushed prior to installa-
tion. Turn off water supply.
Measure the distance from tile surface to NPT el-
bow (connector inside the wall). If the measurement
equals or is less than 1½” continue to step 1.
If it is more than 1½” install the brass nipple between
the connector and the elbow. Add PTFE tape to both
threads.
1. Add thread seal tape (plumber’s tape) to the
threads of the connector.
2. Make sure the shower pipe fitting is clean of dirt.
Screw the connector into the shower outlet. Con-
trol the alignment (threads down).
3. Attach the shower column to the connector.
4. Attach the diverter to the shower column.
5. Attach the double-sided tape (A) to the mounting
plate (B). Place the wall mount to the peg behind
the diverter (C).
6. Set the shower column straight using a level.
Mark the placement for the wall mount to the
wall. (Go to step 7 if using screws.) Clean the wall
area behind the diverter to secure a solid con-
nection. Remove the liner from the double-sided
adhesive (5.A). Firmly press the mount to the
marked spot on the wall for 30 seconds.
7. Mounting with screws (optional): Mark the loca-
tion of the screws. Drill holes. Add screw anchors
and silicone to the holes. Attach the wall mount.
8. Screw in the flange.
9. Adjust the wall mount to ensure the shower col-
umn stands parallel to the wall and tighten the 2
set screws.
10. Attach the upper pipe into the connector.
11. Fasten the set screw under the pipe.
12. Ensure the gasket (D) is correctly in place and
attach the shower plate. Wash your hands or use
gloves to avoid getting grease on the head and
nozzles.
13. Attach the handheld shower. Notice the orienta-
tion of the hose (hex end to diverter, conic end to
handheld)
Open water supply and ensure there are no leakages.
1
3
4
2
THREADS
