Fenix NEMESIS PRO, Инструкция по эксплуатации

Страница: 14 / 24

14 14
ENGLISH
4. HOW TO USE
1. Place the lifting tower over a firm and flat
surface on its working place.
2. Release the metal knob (W) and put the
safety pin (V) in open position (T). Pull the
handle (L) and press down. Move the safety
pin (V) to closed position (S) and continue
pressing until the safety pin (V) is adjusted to
the desired height. Retighten the metal knob
(W).
3. The lifting tower has an extension bar (Z)
of 60cm that allows to reach the maximum
height. In case of need, release the plastic
knob (C) and remove the extension bar (Z)
from its transport support (X). Place the ex-
tension bar (Z) on the upper bar and tighten
the butterfly screw (P) to fix it.
4. Put the load on the top of the lifting tower
using the suitable support, in order to make
the load work only vertically. The minimum
load must be 25kg.
5. Elevation: To lift the bars, follow a descen-
ding order, that is to say, the first bar to be lif-
ted will be always the highest one. Release the
safety pin (A) in open position (T) and turn
the winch handle (B) clockwise, lifting the
load until the desired height. Immediately
afterwards, move the safety pin (A) to clo-
sed position (S), until the end of the section
has been reached. Go on successively to the
different positions of each of the bars, until
the desired height is reached. In case the pin
is hard to pull out, a small number of move-
ments should be made with the winch until
founding the right position where the pin
is released and can be pulled out comforta-
bly. Under no circumstances any of the pins
should be pulled with force.
In case of the lifting tower does not need to
be raised to its maximum height, it is recom-
mended to raise all the bars proportionally
according to the height, and not only one of
them.
6. Lowering: Follow an ascending order to
lower the bars, that is to say, the first bar to
be lowered will be the lowest one. To relea-
se the safety pins (A), the load must be lifted
slightly with the winch. In the normal wor-
king position, the weight of the load prevents
the safety pins from being released. Once
the safety pin (A) is released, it moves to the
open position (T), turn the winch handle
(B) slightly counterclockwise. Immediately
afterwards, move again the safety pin (A)
to closed position (S), until the end of the
section. Repeat the same steps successively
until it is completely folded to its minimum
height. Release the butterfly screw (P) to be
able to remove the extension bar (Z). Put it
back into its transport support (X) by adjus-
ting the plastic knob (C).
7. For the lifting tower transport, it is neces-
sary to bring down all bars and place the sa-
fety pins (A) in closed position (S). Release
the metal knob (W), put the safety pin (V) in
open position (T) and pull up the handle (L).
Put the safety pin (V) in closed position (S)
and keep pulling up until the safety pin (V)
adjusts into the closest hole from the winch.
Retighten the metal knob (W).
Fig. 1