WIRING DIAGRAM & INSTRUCTIONS
COLOR
FUNCTION POLARITY
CONNECTION
Red
Mode 1
12v (+)
Latching Switch
Yellow
Mode 2
12v (+)
Latching Switch
Black
Ground
12v (-)
Chasis Ground
Blue
Pattern
12v (-)
Momentary Switch
WIRING DIAGRAM
WIRING DIAGRAM AND INSTRUCTIONS:
1.
To activate the unit, extend the red (+) or yellow (+) wire
to a 12V post. Extend the black (-) wire to the ground post
of the vehicle's battery. Please note that mode 2 overrides
mode 1.
2.
Momentarily connect the blue wire to the Ground (12V-)
to cycle through the flash patterns.
3.
Synchronization: To Sync two or more light heads
together:
A.
Apply 12V+ power to the red or yellow (+) wire and
apply 12V- to black wire to power the unit on.
B.
Cycle through all patterns by tapping the blue
(pattern select) wire to the activated black ground wire
until the desired pattern is selected.
C.
Connect one of the same colored mode wires (red
or yellow) of the two light heads together; connect
the black wires of the light heads together and then
connect the blue wires of the light heads together.
ALTERNATE LIGHT HEADS:
D.
Follow steps A-B.
E.
For the light heads to alternate, one light head must
be set as master and the other as slave on the mode
wire intended for use. To do so, hold the blue (flash
pattern changer) wire to ground for 3 seconds.
If all LEDs turn on, this indicates master mode. If no
LEDs turn on, this indicates slave mode.
F. Follow step C. Change patterns by tapping the blue
wire to the activated black ground wire.
FENIEX
//
2019
// INSTRUCTION MANUAL // v1.0
WEB
//
www.feniexindustries.com
5
TM
