700735021 E Rev.
A-17
SAFETY
FIG. 31:
Warning - safety sign (6)
Read and understand instructions before operating jack.
Never attempt to move pull pin when there is any load on
the jack. Doing so could cause the trailer to move
suddenly.
Spring return drop leg will naturally retract very quickly.
Non-spring return drop leg will naturally fall. Keep clear of
moving drop leg.
FIG. 32:
Warning - safety sign (7)
Jack will support vertical loads only. Block the wheels and
support the tongue on blocks when the baler is not
hitched to tractor.
FIG. 33:
Caution - safety sign (8)
Pinchpoint. Watch your hands and fingers.
FIG. 31
!
!
WARN ING
0926035 (C)
READ & UNDERSTAND INSTRUCTIONS BEFORE OPERATING JACK
NEVER ATTEMPT TO MOVE PULL PIN WHEN THERE IS ANY LOAD ON THE JACK.
DOING SO COULD CAUSE THE TRAILER TO MOVE SUDDENLY.
SPRING RETURN DROP LEG WILL NATURALLY RETRACT VERY QUICKLY.
NON-SPRING RETURN DROP LEG WILL NATURALLY FALL.
KEEP CLEAR OF MOVING DROP LEG.
To obtain instruction sheet contact:
Cequent-Trailer Products, Inc.
(800)604-9466
DROP LEG PULL-PIN ENGAGED
(CLOSED)
DROP LEG PULL-PIN DISENGAGED
(OPEN)
NO CLEARANCE
Non-Spring Return Drop Leg Operation:
WARNING:
Drop leg will naturally fall.
1) Verify that the jack is not supporting
any load.
2) If retracted, grasp the handle of foot
plate to control the fall of the drop leg.
3) Disengage drop leg pin by rotating to
the disengaged position.
4) Carefully move the drop leg to the
desired position.
5) Engage drop leg pin by rotating to
the engaged position and into the
desired adjustment hole.
6) Verify that the drop leg pin is fully
inserted into the jack by checking for no
clearance between the drop leg pin
and housing. If you see clearance, you
must adjust the drop leg to fully seat the
pin into the hole location. If you are
unable to fully seat the pin, DO NOT USE.
Spring Return Drop Leg Operation:
WARNING:
Drop leg will naturally
retract very quickly.
1) Verify that the jack is not supporting
any load.
2) If extended, place your foot on foot
plate to control the return of the drop
leg.
3) Disengage drop leg pin by rotating
to the disengaged position.
4) Carefully move the drop leg to the
desired position using your foot.
5) Engage the drop leg pin by rotating
it to the engaged position and into the
desired adjustment hole.
6) Verify that the drop leg pin is fully
inserted into the jack by checking for
no clearance between the drop leg
pin and housing. If you see clearance,
you must adjust the drop leg to fully
seat the pin into the hole location. If
you are unable to fully seat the pin,
DO NOT USE.
0926035
6
FIG. 32
879197D
7
FIG. 33
! CAUTION !
PINCHPOINT
WATCH YOUR
HANDS AND
FINGERS
0926034 (C)
0926034
8
