1.1.12 Before you start the engine
Start the engine only from the operator
compartment. Never short across the starter
terminals or batteries. Shorting can damage
electrical system or cause unexpected machine
movement.
Adjust the seat so full pedal travel can be achieved
with operator's back against seat back.
Make sure the machine is equipped with a lighting
system sufficient for job conditions. Make sure all
machine lights are working properly.
Before starting the engine or moving the machine,
make sure no one is under, around or on machine.
Make sure area is free of personnel.
To honk horn the key must be turned to “run” to
enable the horn. As a warning honk horn twice, to
alert others.
GUID-6CB742A7-222E-47ED-9806-1887BFD0CF24-high.jpg [High]
Fig. 5
1.1.13 Start the engine
Move all hydraulic controls to the hold position before starting the engine.
Make sure the transmission control lever is in the park position.
Diesel engine exhaust contains products of combustion which can be dangerous. Always operate the
engine in a well ventilated area. If in a closed in area, vent the exhaust to the outside.
WARNING:
Machine will turn if turning the steering wheel when the transmission control lever is in
neutral and the engine is idling.
WARNING:
Do not use ether at any time. Use will cause engine damage and/or personal injury.
Do not start the engine until the area is free of personnel to prevent personal injury because of unexpected
machine movement.
1.1.14 Before operation
Clear all personnel from around the machine and the area.
Clear all obstacles from machine's path. Be careful of dangers, (electrical power lines, ditches, etc).
Make sure all the windows are clean and attached in the closed position.
Adjust the rearview mirrors for best visibility near the machine. Make sure the horn, backup alarm (if
equipped) and all other warning devices are working correctly.
On the drawbar-towed implements, fasten a transport chain of sufficient capacity between the machine
drawbar support and implement. Give only enough slack in the chain to permit turning.
Only one instructor must be permitted to ride in the machine cab. Instructor must be seated in the
instructor seat with the seat belt fastened.
1.1.15 Procedures for operation
The machine will turn with the transmission control lever in the neutral position when the engine is
operating and the steering wheel is turned.
GUID-344A454E-7D26-49D5-9AB4-3FEEFA88AFD5 [V3]
GUID-B4E17348-4D58-4C2D-AFDB-7B7E7FC9E6AD [V2]
GUID-86EB8255-6A7F-48A0-9673-C9A47A0DB5E9 [V3]
GUID-2FAD1972-8BC6-4DCB-AD6B-A6507DBBE785 [V6]
1. Safety
Rubber Track Tractor
19
ACW3842360_V02
