Fender Passport PD-150, Руководство по обслуживанию

Страница: 4 / 48

PASSPORT
®
PD-150
(This is the model name for warranty claims)
4
Product specifications are subject to change without notice
SERVICE NOTES
The following describes the procedure to dismantle
the PD-150 Cabinets.
STEP A: PD-150 CABINET
A1. Unscrew two M4 machine screws on each of
the left and right hatches on either side of the
unit (8 total).
A2. Unscrew two M3 pan-head machine screws
on the handle cover and detach it.
A3. Place the unit upside down. Unscrew eight M4
self-tapping screws off the foot standers.
A4. Detach the foot standers. There are six M3
self-tapping screws in the middle portion.
A5. Unscrew three M3 self-tapping screws located
on the right-hand-side.
A6. Place the unit in the normal position.
A7. Locate the four M3 and two M4 self-tapping
screws on the top and unscrew them.
A8. Separate the left and right cabinets.
A9. Locate the UHF and VHF antennas on the
right and left cabinets respectively.
A10. De-solder both antennas.
A11. Unscrew three M3 self-tapping screws on left
and right side panels (6 total) of the tower
metal assembly.
A12. Unscrew eight M2.6 and eight M3 self-tapping
screws (three on top of front panel, three on
top of rear panel, and two on metal cover).
A13. Detach the left and right metal side panels.
A14. Detach the top metal cover.
A16. Unscrew seven outer M3 self-tapping screws
on the rear panel.
A17. Detach all connectors.
A18. The procedure is completed.
STEP B: PD150 MIXER PCB
B1. Detach 24 knobs and their nuts.
B2. Detach the Reverb PCB assembly.
B3. Unscrew nine M3 machine screws from the
mixer PCB assembly.
B4. Detach all connectors.
B5. The procedure is completed.
STEP C: PD150 DSP REVERB PCB
C1. Detach all connectors.
C2. The procedure is completed.
STEP D: PD150 INPUT PCB
D1. Unscrew six screws and nuts from the front
panel.
D2. Detach all connectors.
D3. The procedure is completed.
STEP E: PD150 POWER AMP PCB
E1. Unscrew four screws connecting the heat sink
to the side brackets (two on either side of
tower).
E2. Detach all connectors.
E3. The procedure is completed.
STEP F: PD150 SMPS PCB
F1. Unscrew three screws from the front panel.
F2. Detach all wiring and connectors.
F3. Unscrew six screws from the top cabinet of
the SMPS.
F4. Unscrew three screws from the bottom cabi-
nets of the SMPS.
F5. Detach the spacer from the wiring of the
SMPS.
F6. Unscrew the earthing M4 nut.
F7. Detach the mains connector from the AC inlet.
F8. Unscrew five screws from the SMPS PCB as-
sembly
F9. The procedure is completed.