1
FWG
1010
Symbols Used
The lightning flash with arrow point in an equilateral trian-
gle means that there are dangerous voltages present
within the unit.
The exclamation point in an equilateral triangle on the
equipment indicates that it is necessary for the user to
refer to the User Manual. In the User Manual, this symbol
marks instructions that the user must follow to ensure
safe operation of the equipment.
Safety and Environment
Safety
• Do not spill any liquids on the equipment.
• Do not place any containers containing liquid on the device or
the power pack.
• The equipment may be used in dry rooms only.
• The equipment must only be opened, serviced, and repaired by
authorised personnel. The equipment contains no user-service-
able parts.
• Before connecting the equipment to power, check that the AC
mains voltage stated on the supplied AC adapter is identical to
the AC mains voltage available where you will use the equip-
ment.
• Only operate the equipment with the supplied AC adapter with a
12-VDC output. Using adapters with a different output voltage or
current type may cause serious damage to the unit.
• If any solid object or liquid should get into the equipment, shut
down the system immediately. Disconnect the AC adapter from
the power outlet at once and have the equipment checked by
our customer service department.
• If the equipment is not going to be used for a long time, discon-
nect the AC adapter from the power outlet. Please note that if you
turn the equipment off while leaving the AC adapter plugged in,
it is not fully isolated from the power supply.
• Do not place the equipment near heat sources such as radiators,
heating ducts, amplifiers, etc. and do not expose it to direct sun-
light, excessive dust, moisture, rain, mechanical vibrations, or
shock.
• To avoid hum or interference, route all audio lines, particularly
those connected to the microphone inputs, away from power
lines of any type. If you use cable ducts, be sure to use separate
ducts for the audio lines.
• Clean the equipment with a moistened (not wet) cloth only. Be
sure to disconnect the AC adapter from the power outlet before
cleaning the equipment. Never use caustic or scouring cleaners
or cleaning products containing alcohol or solvents since these
may damage the enamel and plastic parts.
• Only use the equipment for the applications described in this
manual. Fender cannot accept any liability for damages resulting
from improper handling or misuse.
Environment
• The power supply unit consumes a small amount of electricity
even when the unit is switched off. To save energy, unplug the
power supply unit from the socket if you are not going to be us-
ing the unit for some time.
• The packaging is recyclable. Dispose of the packaging in an ap-
propriate recycling collection system.
• If you scrap the unit, separate the case, electronics and cables
and dispose of all the components in accordance with the appro-
priate waste disposal regulations.
FCC STATEMENT
The transmitter has been tested and found to comply with the
limits for a low-power auxiliary station pursuant to Part 74 of the
FCC Rules. The receiver has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-
ment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiv-
er.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Shielded cables and I/O cords must be used for this equipment to
comply with the relevant FCC regulations. Changes or modifica-
tions not expressly approved in writing by FMIC may void the user’s
authority to operate this equipment.
The receiver complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause unde-
sired operation.
USA only: FCC CONSUMER ALERT
Most users do not need a license to operate this wireless system.
Nevertheless, operating this system without a license is subject to
certain restrictions: the system may not cause harmful interference;
it must operate at a low power level (not in excess of 50 milliwatts);
and it has no protection from interference received from any other
device.
Purchasers should also be aware that the FCC is currently evaluating
use of wireless systems, and these rules are subject to change. For
more information, call the FCC at 1-888- CALL-FCC (TTY: 1-888-TELL-
FCC) or visit the FCC’s website at www.fcc.gov/cgb/wirelessmicro-
phones.
EN
GL
ISH
