Fender Cyber-Deluxe DSP 7, Руководство по эксплуатации

Страница: 21 / 46

w ww ww w. .f f e e n n d d e e r r. .c co om m
✧
w ww ww w. . m m r r g g e e a a r r h h e e a a d d . .n ne et t
19
Presets In
–
Depth
P P
P P
rr
rr
e e
e e
s s
s s
e e
e e
tt
tt
E E
E E
d d
d d
ii
ii
tt
tt
M M
M M
e e
e e
n n
n n
u u
u u
s s
s s
This section explains how to edit preset parameters that are within menus.
The edit process : 1) Access a parameter (menu item) using a button listed
below, 2) Edit the parameter value using the DATA WHEEL, 3) Press EXIT,
4) Save the edited preset using the procedure on page 12, if desired.
Parameters for: Button How to Edit
Reverb . . . . EDIT {J} . . . . . . . . . See page 20
Modulation effects . . . . EDIT {M} . . . . . . . . . See page 20
Delay effects . . . . EDIT {P} . . . . . . . . . See page 22
Compressor . . . . COMP {Z} . . . . . . . . See page 23
Noise Gate . . . . N GATE {AA}. . . . . . See page 23
Expression pedal . . . . UTILITY {EE}. . . . . . See page 26
Effects Editing
You can access parameters for the currently selected effect in each effects
group by pressing the EDIT button one or more times. You can then edit the
parameter value by turning the DATA WHEEL.
When an EDIT button is pressed, a two letter parameter code and the
parameter’s current value are alternately displayed. The green EDIT LED
also flashes until editing has ended.
After editing one or more parameter values with the DATA WHEEL, press
EXIT to end the edit process. Ending the edit process will keep your
changes active
. . . Save your changes to a new preset to secure them.
The EDIT parameters for REVERB, MOD. F/X and DELAY effects groups are
covered on the next 3 pages. Normally, the EDIT button will access one
parameter for each REVERB and MOD. F/X and 2 parameters for DELAY,
but in the Advanced Edit Mode you have access to 4 parameters for each
effects group selection (see Advanced Edit Mode, below).
Advanced Edit Mode
To enable the Advanced Edit Mode: Turn the amplifier OFF. Press and hold
in the three EDIT buttons {J, M and P}, then turn the amplifier ON. Release
the EDIT buttons after the display lights up. Now each of the EDIT buttons
will incrementally access 4 parameters.
To disable the Advanced Edit Mode: Turn the Cyber-Deluxe™ amplifier OFF
and ON again.
%
Generally, it is unnecessary to edit the
additional parameters of Advanced Edit
Mode. The most commonly adjusted
parameter settings are
always
accessible using the EDIT buttons.
%
Parameter “code” and parameter
“value” alternately display when any
EDIT button is pressed.
%
EDIT operations automatically return
the amp to the play mode after 45
seconds of inactivity.
VIBRATONE
CHORUS
PHASER
WAH
TREMOLO
FLANGE
T
P
EDIT
DUCKING
TAPE
MONO
TAP EDIT
AMBIENT
HALL
ROOM SPRING
ARENA
PLATE
EDIT