NOTE: DO NOT BLOCK THE AIR FLOW TO THE
REAR PANEL, FOR EXAMPLE, BY BACKING THE
AMPLIFIER UP AGAINST A WALL.
The rear panel is
used to keep the output devices from getting too hot. Should
the amplifier overheat, a thermal switch will shut the
amplifier off until the output devices cool.
POWER CORD -
This amplifier is equipped with a
grounding type supply cord to reduce the possibility of
shock hazard. Be sure to connect it to a grounded AC
receptacle. The line cord should be connected to a suitable
power source, in accordance with the voltage and
frequency as shown by the power rating on the rear panel.
DO NOT ALTER THE THREE PRONG PLUG.
If the amp is set up but does not function, check the following items:
- Is the amp power cord plugged into an electrical outlet?
- Is there power at the outlet?
- Are all the control knobs turned up?
- Is the volume control on the instrument turned up?
- Is the instrument properly plugged into the amplifier?
(Eliminate any effect pedals and try another guitar cord.)
If, after checking all of the above, the system is still not performing correctly,
consult your FENDER Service Dealer.
COVERING CARE
The exclusive vinyl covering your
cabinet has been especially designed for years of lasting
beauty. A very light, soapy solution on a sponge may be
used to remove dirt and residue that may accumulate in the
texture. Be careful not to let any liquid come in contact with
the operating surfaces.
UNPLUG THE POWER CORD
BEFORE CLEANING.
Troubleshooters Checklist
BXR 60 Rear Panel
