21
If you wish to remotely control and monitor EDX energizer, then it
firstly must be paired with the gateway.
Pair new –
It is used to pair a new device. The Pairing number screen appears and the blue
LED flashes quickly. Near or far-off pairing may now be carried out.
Pairing may also be started as follows: switch off the energizer by using the
ON/OFF push button in Standby Mode and hold it down for > 5 s; blue LED
indicator light flashes.
The pairing screen lasts 3 minutes. After three minutes, the Near
Pairing Mode ends. EDX energizer automatically switches from this
screen to the previous screen and blue LED indicator light stops indi-
cating near pairing. Exit the pairing screen by pressing the BACK key.
Device list -
The Device list shows the type of gateway on which the fence system is paired
and at the end, the beginning of the gateway MAC address. One fence may be
paired on the maximum of 3 gateways.
By selecting RESET, all paired gateways may be deleted from the fence system, which also
changes the fence MAC address. This means that the gateway will not be able to send or re-
ceive data from the energizer. The function is used to remove the energizer from the gateway,
for example, when selling the fence, so that the original owner is not able to control the new
owner's energizer via the Cloud application.
Near pairing may be carried out by placing the gateway (which is also put into the Pairing
Mode; refer to the gateway Manual) RF antenna and EDX energizer antenna together.
Pairing may also be carried out remotely (EDX energizer does not have to be near the gate-
way). The eight-digit pairing code and Code valid are displayed on the screen. The code is used
for remote pairing of the fence system with the gateway. The same code is recorded in the QR
code. You may read the code by using the mobile phone camera or scan the QR code and then
enter the code in the gateway for pairing.
