Fence Mower FM30, Руководство оператора и по техническому обслуживанию

Страница: 12 / 24

Wright Fence Mower, LLC
MAINTENANCE
FM30-FM60 8
Gearbox Lube Level
After periods of heavy use (at least every 10 hours of
operation), or after repairing the gearbox, or if lubricant
leaks are observed, check gearbox lubricant levels.
Caution
DO NOT operate the mower if lubricant level is low.
Replace damaged seals or gasket and add lubricant to
the correct level. DO NOT OVERFILL.
 Position mower on a level surface.

Visually check and look for leaks.

Remove gearbox lubricant level plug and check
lubricant level. Lubricant should be at or near
bottom of hole.

If lubricant is low, remove gearbox Fill/Pressure
Relief Plug (P/N 15664) and add SAE 85-140
lubricant until lubricant starts to flow from level
inspection hole. DO NOT OVERFILL. Overfilling will
induce leakage and cause damage to seals and
gaskets.

Replace Lubricant Level Plug and Fill/Pressure
Relief Plug (P/N 15664).
Caution
FILL/PRESSURE RELIEF PLUG (P/N 15664) Must
not be
CLOGGED OR RESTRICTED . Must be able
to vent gearbox.
Checking Gearbox Lubricant Level
GEARBOX
Gearbox Seals and Gaskets
Check the gearbox for leaks around the seals and
gasket daily when the mower is in use. If a shaft seal
or gasket is damaged, lubricant will leak out of the
gearbox.
Input Shaft Seal and Cover Gasket
 Remove gearbox cover.

Replace shaft seal and cover gasket.

Replace gearbox cover.

Replace drain plug and refill with lubricant.
Output Shaft Seal

Remove gearbox from top deck. Drain lubricant.

Replace shaft seal.
 Install gearbox on top deck.
 Refill with lubricant and replace drain plug.
Gearbox Mounting Hardware
Check that the gearbox is tight on the mower top deck
each day the mower is in use. If it becomes loose,
tighten the mounting bolts.
TAIL WHEELS
Replace Wheel
Caution
Adequately support the mower and the wheel before
removing the axle. Both the wheel and the mower are
heavy and could cause damage to the mower or
serious injury if dropped.
 Remove wheel axle nuts and axle.
 Remove wheel.

Position wheel in pivot yoke.

Install wheel axle and nuts.
Replace Pivot
 Raise and support mower using approved means.
Support mower high enough so that pivot shaft can
be removed from tail wheel pivot bracket.
Fill/Pressure
Relief Plug
Oil Level
Plug