Felt CALPAC IA, Руководство пользователя, Страница: 11 / 11

11
Step 8:
Attach the front of the top of the CALpac together using the remaining 12mm M3 screw. As before, note that the
screws are self-tapping, so great care must be taken on the first installation. Tighten to 2Nm.
Step 9:
While flexing the rubber part of the cover out of the way, carefully screw the box down to the frame using the (4)
longer (16mm) screws. Tighten to 2Nm.
Step 10:
To help install the remaining screw at the front of the CALpac, use a little bit of grease on the Hex driver to retain
the screw as you insert it through the hole. Tighten to 2Nm.
Step 11:
Once installed, your new CALpac should appear like the above image. Note that variations to this setup will occur
depending on your bike’s specific cable routing. Refer to pages 4-10 for specific routing information.
IA/IAX CALPAC INSTALL
(CONTINUED)