Fellowes SPL A4, Руководство пользователя

Страница: 6 / 66

4
English
Set-up
Using the illustration on the inside of the manual cover as a reference, attach the support tray
to the back of the machine with the two screws included in the package
Operation
To begin laminating, plug in the machine and press the power button . On the control panel
, then press start , which will cause the orange standby light
D
to go on.
Hot Lamination
Using the guidelines printed on the top of the machine:
•
Set temperature
by pressing , which will cause the temperature light to go on.
The digital temperature display
A
will show 110° C if this is the first use, but otherwise will
show the last temperature used. Press plus or minus until you see the temperature you
want. Note: Because even standard paper may vary in weight and some inks are heat sensi-
tive, you may have to use a somewhat higher or lower temperature – roughly 5° more or less
– to get optimum results.
•
Set speed
by pressing a second time, which will cause the speed light to go on.
The digital speed display
B
will show “4” if this is the first use, but otherwise will show the
last speed used. Press plus or minus until you see the speed you want.
Then press forward
▲
to start the rollers turning. Although the
laminator will warm up without the rollers in motion, this ensures
that the heat will be evenly distributed. As soon as the selected
temperature has been reached, the green ready light
C
will go
on. Allowing for a free margin of at least 3 mm (1/8 inch), on
the unsealed edges, insert the sealed edge of the pouch or
mounting board into the entry , as shown at the right.
If you see the material is not going in straight and might get
damaged, use the reverse mode : Press stop
■
, then press and
hold reverse
▼
until you have backed the material out of the
entry completely. Realign and press forward
▲
to begin again.
Remove your material from the support tray after it has cleared the exit . If you are finished
with the job, but plan to use the laminator again soon, press start to put it into the
standby
mode . If you forget, it will switch itself into this mode after one hour of inactivity. Press start
again to resume work, or press the power button to turn off the machine.
Cold Lamination
Using the same
temperature
and
speed selection
procedure as with hot lamination, lower
the temperature until the digital display is blank. The cold mode light will go on at this
point to confirm the change in mode. Then select a speed of 5 or 6, depending on the contents
and pouch thickness.
Press forward
▲
to start the rollers turning. (If the laminator is hot, you can accelerate the
cooling process by passing through the cleaning sheet included in the package and/or turning
up the roller speed to 7, 8 or 9.) When the green ready light
C
goes on, turn the speed back
to 5 or 6 if necessary, then: