3
Eliminates frustrating jams by preventing overloads and powering through misfed paper.
JAM PROOF SYSTEM OPERATION*
*100% Jam Proof when used in accordance with user manual
PREvENTIvE MAINTENANCE AND MISCELLANEOUS TROUBLESHOOTING
• Self Cleaning Cycle: Shredder periodically cycles in forward and reverse lasting 3-6 seconds (SB-125Ci).
• Empty wastebasket when bin full indicator lights up.
• Shredder won’t run if the door is open, or bin needs to be emptied.
• Maintenance is an important part of protecting your investment. Don’t forget our oil (35250) and shredder bags (36054).
• When shredding for a prolonged period of time, the motor can become warm and require a cool down period. When this occurs the overheat indicator will alert you to the problem.
This model will require 45 minutes to cool down.
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
Advanced Jam Prevention- Electronically
measures paper thickness to prevent paper jams:
Remove several sheets until
indicator is below red.
Continue 100% Jam
Proof Shredding
If a misfeed
occurs:
If
illuminates after paper has been
reversed, press reverse and remove paper.
Otherwise, regular shredding will resume.
1
2
3
Up to RED: Too many
sheets have been inserted.
Up to GREEN: More sheets
can be added.
Up to YELLOW: Productivity
is optimized.
All indicators light up and
shredder pauses for 3-6 seconds
Wait for flashing to stop after automatic correction
is complete. Regular shredding will resume.
TO CLEAN THE SENSORS
CLEANING AUTO-START INFRARED SENSORS
BASIC PRODUCT MAINTENANCE AND TROUBLESHOOTING
Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors
may become blocked by paper dust causing the motor to run even if there is no paper present
(Note: two paper detection sensors are located in the center of the paper entry)
.
All cross-cut shredders require oil for peak performance. If not oiled, a
machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
OILING SHREDDER
15
15
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Turn off and unplug
shredder
Locate Auto-start
infared sensor
Using cotton swab, wipe
away any contamination
from the paper sensors
Dip cotton swab in
rubbing alcohol
Shred one sheet
Press and hold forward
( ) 2-3 seconds
*Apply oil across entry
SAFESENSE
®
TECHNOLOGY OPERATION
WHEN IN SLEEP MODE
SLEEP MODE
In sleep mode
To get out of sleep mode
touch control panel
insert paper
or
SET-UP AND TESTING
Turn the shredder ON
( ) to activate SafeSense
®
Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active and
working properly
If hand is held on SafeSense
®
area more than 2 seconds
shredder will shut off
3
AUTO
AUTO
AUTO
1
2
4
2
AUTO
AUTO
AUTO
3
1
AUTO
1
2
3
AUTO
1
2
4
3
