Pullout bin
ENGLISH
Models PS-62C
Paper entry
Control switch
Window
Shredder head
CAPABILITIES
Will shred:
Paper, credit cards and staples
Will not shred:
Continuous forms, adhesive labels, transparencies,
newspaper, cardboard, paper clips, laminates or plastic other than
noted above
Paper shred size:
Confetti-Cut ..................................................... 5/32” x 2” (3.9 x 50mm)
Maximum:
Sheets per pass (Confetti-Cut) ............................................................... 6*
Passes per day ................................................................................25-50
Cards per pass ........................................................................................1
Cards per day .......................................................................................10
Paper width ...........................................................................9” (229mm)
Continuous operation ............................................................... 10 minutes
*20lb., 8.5”x11” paper at 120v, 60Hz, 2.0Amps, heavier paper, humidity or
other than rated voltage may reduce capacity.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Always unplug
when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc. – away from shredder openings. If object enters top
opening, switch to Reverse (R) to back out object.
• Never use aerosol, petroleum based or other flammable
products on or near shredder. Do not use canned air on
shredder.
• Do not use if damaged or defective. Do not open shredder
head. Do not place near or over heat or water source.
• Avoid touching exposed blades under Confetti-Cut shredder head.
Auto-On (I)
Off (O)
Reverse (R)
2
OPERATION
TROUBLESHOOTING
Set to Off (O)
and plug in
Set to Off (O)
and unplug
Set to Auto-On (I)
Press Auto-On (I)
Feed into paper entry
and release
Hold card
at edge
Feed into center of entry
and release
Continuous operation:
10-minute maximum
NOTE:
Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
10-minutes will trigger 20-minute
cool down period.
*Apply oil
across entry
Set to Auto-On (I)
Set to Off (O)
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Shred one sheet
Set to Reverse (R)
2-3 seconds
Confetti-Cut:
Run regularly in reverse for
one minute
Lubricate when bin is full, or
immediately, if:
• Capacity decreases
• Motor sounds different, or
Shredder stops running
Paper jam:
Set to Off (O) and empty bin. Replace bin and follow any or all of the below procedures.
Shredder comes ready to use. Insert waste bag for easy disposal.
Shredder doesn’t start:
Alternate slowly back and forth
Set to
Reverse (R)
Set to Off (O)
and unplug
PAPER
CARD
Make sure shredder is plugged in
Make sure bin is pushed in
Wait 20 minutes for motor to cool down
Remove and empty bin
WARRANTY
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the
machine to be free from defects in material and workmanship for 5 years from
the date of purchase by the original consumer. Fellowes warrants all other parts
of the machine to be free of defects in material and workmanship for 1 year from
the date of purchase by the original consumer. If any part is found to be defective
during the warranty period, your sole and exclusive remedy will be repair or
replacement, at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized
repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE
APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be
liable for any consequential or incidental damages attributable to this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of
this warranty are valid worldwide, except where different limitations, restrictions,
or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or
your dealer.
MAINTENANCE
Gently pull uncut paper
from paper entry.
Plug in.
Set to
Reverse (R)
Follow oiling procedure below and repeat twice.
3
