Feed paper straight into
paper entry and release
Feed into center of
entry and release
When finished
shredding set
to OFF (O)
3
15
15
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
BASIC PRODUCT MAINTENANCE
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
Gently pull uncut
paper from paper
entry. Plug in.
Set to Off (0)
Press Auto-On (I)
PAPER/CARD
BASIC SHREDDING OPERATION
Check paper amount
Plug in and put
disconnect power
switch in ON (–) position
Continuous operation:
Up to 5 minute maximum
NOTE:
Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
5-minutes will trigger
15-minute cool down period.
Set to Reverse (R)
for 2-3 seconds
Press and hold
Reverse (R)
PAPER JAM
Alternate slowly back and forth
Press and hold
Reverse (R)
Set to Off (O)
and unplug
ADVANCED PRODUCT FEATURES
SAFESENSE
®
TECHNOLOGY OPERATION
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
TROUBLESHOOTING
A. Overheat Indicator:
When the Overheat Indicator is illuminated, the shredder has exceeded its maximum
operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will
not operate for the duration of the recovery time. See Basic Shredding Operation for more information
about the continuous operation and recovery time for this shredder.
B. SafeSense
®
Indicator:
If hands are too close to the paper entry, the SafeSense
®
indicator will illuminate
and the shredder will stop shredding.
Turn the shredder ON
( I) to activate
SafeSense
®
Touch test area and
look for the SafeSense
®
indicator to illuminate
SafeSense
®
is active
and working properly
2
3
4
5
6
1
2
3
1
2
3
1
2
3
4
5
6
A
B
1
or
