2
CAPABILITIES
Will shred:
Paper, plastic credit cards, small paper clips and staples
Will not shred:
Continuous forms, CD/DVDs, adhesive labels, transparencies,
newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic
other than noted above
Paper shred size:
Cross-Cut ..........................................................................5/32 in. x 2 in. (4mm x 50mm)
Maximum:
Sheets per pass ........................................................................................................... 10*
Cards per pass ............................................................................................................... 1*
Paper entry width ........................................................................................9 in. (230mm)
* 8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 3.5Amps; heavier paper, humidity or
other than rated voltage may reduce capacity. Maximum recommended daily usage rates:
100 sheets; 5 credit cards.
10 sheets per pass.
Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
ENGLISH
Model 60Cs
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
15
• Operation, maintenance, and service requirements are covered in the instruction
manual. Read the entire instruction manual before operating shredders.
• Keep away from children and pets. Keep hands away from paper entry. Always
set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder
openings. If object enters top opening, switch to Reverse (
) to back out object.
• DO NOT use aerosol products, petroleum based or aerosol lubricants on
or near shredder. DO NOT USE “CANNED AIR” OR “AIR DUSTERS” ON
SHREDDER. Vapors from propellants and petroleum based lubricants may
combust causing serious injury.
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
• This shredder has a Disconnect Power Switch (F) that must be in the ON (I)
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
KEY
H. Control switch and LEDs
1. Auto-On (green)
2. OFF
3. Reverse
4. Overheat (red)
5. SafeSense
®
(yellow)
A. Shredder head
B. Paper/credit card entry
C. SafeSense
®
Technology
D. Window
E. Bin
F. Disconnect power switch
1. OFF
2. ON
G. See safety instructions
15
15
15
15
A.
G.
H.
F.
C.
B.
D.
E.
Feed paper/card
straight into paper
entry and release
When finished shredding
set to OFF ( )
Set to Auto-On ( )
PAPER/CARD
BASIC SHREDDING OPERATION
Plug in and put
disconnect power
switch in ON (I) position
Continuous operation:
Up to 6 minute maximum
NOTE:
Shredder runs briefly after each pass to clear
entry. Continuous operation beyond 6-minutes will
trigger 20-minute cool down period.
3
1
2
4