Page 3
insert bracket clamps
onto rear of worksurface
The following procedure shows a 46" wide screen. The assembly procedure is the same for all screen widths, except that three brackets instead of two
are used for 58" and 70" widths. Contact Customer Service if you have any questions.
Step #1: attach bracket to screen
The back of the bracket fits into indentations on the front of the screen.
• If necessary, turn the knob to open the bracket to allow access to both
screw holes.
• Position the back of the bracket into the indentation with the knob on
the bottom.
• Attach the bracket using the screws provided. Tighten securely.
Step #2: attach screen to desk or table
The screen brackets can accommodate worksurface thicknesses from ½" to 1.6".
A minimum depth of 1.2" is required for secure bracket attachment.
• Position the bracket clamps onto the rear of the worksurface. The entire top flange of the
bracket should be on the top of the surface.
• Turn the knob on each bracket to tighten securely.
• Check that the screen is securely in place.
Centro Assembly
open bracket
fit rear
of bracket
into
indentation
attach with
two screws
½" to 1.6"
1.2"
minimum
screen
tighten
securely
