Fellowes Binding Machine, Инструкция по эксплуатации

Страница: 6 / 11

4
IMPORTANT SAFETY INSTRUCTIONS
R E AD AL L INS TR UCT IONS BEF OR E USI NG
With both
m an u al a nd el ectr ic
machines, always:
• Remove staples and other metal from sheets before punching
• Keep the transparent die cover closed during punching, and
• Keep the covers closed when the machine is not in use.
Never attempt to open or otherwise repair either of these machines.
With the
m a n u a l
model, also make sure the punching bar
.
is lowered when not in use
in order to avoid bumping or catching your arm. With the
e l e c t r i c
model, treat it as you
would any other piece of electrical equipment:
• Keep it away from heat or water sources
• Plug it in near an easily accessible outlet
• Turn it off after each use, and
• Unplug it when not in use for an extended period.
S e t - u p
Before you can operate the
m a n u a l
machine, you need to assemble the punching bar
.
.
Using the illustration on the inside of the manual cover as a reference
!
, attach the
cushioned hand grip first to one arm of the machine and then to the other. (We have
included a screwdriver and screws for this purpose.)
There is no assembly required for the
e l e c t r i c
model. Simply plug it in. If you would like to
work “hands free” while binding documents, also plug the cable of the foot pedal
/
into
the jack
0
on the right side of the machine.
O p e r a t i o n
Before binding the first document, you should punch several sheets of scrap paper to
remove any
f a c t o ry -ap pli ed gr e a s e
that might remain on the cutting dies. To do this,
open the punch cover
'
and follow the
s t a n d a rd pu nc hi ng p ro c e d u re
for your model:
•
M a n u a l
– Raise the punching bar
.
to a vertical position. Place the long side of the sheet
in the comb-punch entry
"
and press down on the bar
.
as far as it will go. To take full
advantage of the machine’s ergonomic design, do this while standing in front of the
machine and with both hands on the rotating grip. Raise the bar
.
back to a vertical posi-
tion and remove the paper.
•
E l e c t r i c
– Press the power switch
-
and wait for the green standby light
(
to go on. Place
the long side of the sheet in the comb-punch entry
"
and press the start button
)
or foot
pedal
/
, removing paper after you hear the punching action.
Repeat this a few times until the edges of the holes are clean, then do the same with the
ring binder punch
#
. The machine is now
r ead y for use
.