10
UNIT OPERATION
ENERGY SAVER MODE
This feature can be used when the air conditioner is
COOLING
. Based on set temperature, the
fan cycles on and off with the compressor. This mode results in variations of room
temperature and humidity. It is recommended to use this mode when the room is unoccupied.
1.
Press on the
ENERGY SAVER
button.
2.
Press (increase) or (decrease) to set room temperature. The set temperature will
show on the LED display. To alternate between
o
C and
o
F, press and hold for 3 seconds
both keys together.
3.
Press to set fan speed to
AUTO, LOW, MED
or
HIGH
. Each level is matched with an
indicator light going on when selected.
NOTE :
The fan and the compressor may not cycle on and off simultaneously.
SLEEP MODE
• In
SLEEP
mode, the air conditioner adjusts the cooling temperature for a preset period of time.
Using this mode will allow you to maintain a continuous room comfort for a good night sleep.
• When the
SLEEP
mode is on, the set temperature will increase by 2
o
F 30 minutes after the mode
is selected. The temperature will then increase by another 2
o
F after an additional 30 minutes. This
new temperature will be maintained for 7 hours before it returns to the originally set temperature.
This ends the
SLEEP
mode and the unit will continue to operate as originally programmed.
1.
Set to
COOL
mode and adjust the temperature on the air conditioner.
2.
Press on the
SLEEP
button.
3.
This mode can be cancelled at any time during operation ; simply press again on
SLEEP.
SETTING THE TIMER
The timer is used to set an automatic start or shut off.
Automatic start :
1.
Press on
TIMER
until the “
ON
” indicator light goes on - this indicates that the
automatic start program is initiated.
2.
Press (increase) or (decrease) to set the numbers of hours (1-24) before the turn on.
• 0 to 10 hours, the time will increase by 1/2 hour ; 10 to 24, it will increase by 1 hour.
3.
For 5 seconds, the LED display will show the time left before the unit starts ; then, the
display will currently show the set temperature.
Automatic shut off :
Press on
TIMER
until the “
OFF
” indicator light goes on - this indicates that the automatic
shut off program is initiated. Repeat steps 2 and 3 described above for the automatic start.
•
Turning the unit ON or OFF at any time will cancel the TIMER function.
FILTER CLEANING WARNING LIGHT
This feature is a reminder to clean the air filter. It will go on after 250 hours of operation.
1.
When the
CHECK FILTER
light is on, remove and clean the air filter or replace it. Refer to
“Cleaning the air filter” in the “Maintenance” section.
2.
Then put the filter back in place.
3.
To reset, press the
CHECK FILTER
button - pilot light will go off.
