P
age
20
[email protected]
www.FELIXprinters.com
User manual FELIX 3.0 3d printer
When these steps above are OK, you are ready to press that print button.
If the calibration was done correctly, the print should finish without any problem.
If the print looks like the picture above, then congratulations your printer setup is completed!!
If the print fails, it is usually because the distance between the bed and nozzle is too large. Try to adjust the z-
axis limit switch vane to get the distance closer.
To know more about software please continue reading at chapter 7
IMPORTANT:
To keep the hot-end running as long as possible, let the filament run through a dust
collector like a small piece of sponge. The filament picks quite a lot of dust due to static charge or dirt
from the factory. This will all enter the hot-end and partially stick in there and finally clog the nozzle.
When this happens the hot-end needs to be cleaned out while hot from both sides. A tutorial for this
is available on the forum on the website.
NOTE:
If you have a dual extruder, continue to chapter 7
NOTE:
For owners who assembled the printer themselves it is
strongly
recommended
to follow
assembly checks in
appendix 15.
W
ARNING
!
S
URFACE OF HOT
PLATE STILL HOT
!
Tensioning bolt, turn counter clockwise
for more tension on filament.
