Felix Storch Summit CR2B223G, Руководство пользователя

Страница: 12 / 16

11
CARE AND MAINTENANCE
CLEANING YOUR APPLIANCE

Do not use a steam cleaner to clean this appliance. Steam could penetrate electrical components and
cause a short circuit. Pressurized steam could cause permanent damage to the surface and to
components for which the manufacturer can not accept responsibility.

Do not use any sharp pointed objects which could damage the seal between the ceramic surface, the
surrounding frame and the countertop.

Never use abrasive or caustic (oven) cleaners, dishwasher detergent, scouring pads, steel wool or
hard brushes. They will damage the surface.

The ceramic surface can be cleaned using a cleaner for ceramic surfaces. Follow the
manufacturer’s
instructions.

Make sure that no cleaner residue remains on the ceramic surface by carefully wiping the cooktop
with a damp cloth. The residue could damage the cooktop or produce toxic fumes when heated.

Be sure that pot and pan bases are clean and dry. After cleaning, dry the ceramic surface with a soft
cloth to prevent a buildup of lime scale deposits.

Clean any spills immediately before they become difficult to remove.

Clean the appliance regularly, preferably after each use. Allow the appliance to cool before cleaning.

Wipe off any soiling using a damp cloth. Stubborn soiling is best removed with a shielded scraper
blade.

Apply a ceramic cleaner using a soft cloth or paper towel. To remove any lime scale deposits or
metallic residue apply a ceramic cleaner using a soft cloth and a shielded scraper blade if necessary.

After cleaning, wipe the ceramic surface with a damp cloth and dry.

A cleaner with a special additive to prevent water marks and smears on the ceramic surface may be
used.

Any melted solids like sugar, plastic or aluminum foil should be removed as soon as possible, while
the burner is still warm. If they are allowed to harden the cooktop may become pitted.
CLEANING SURFACE UNITS AND REFLECTOR BOWLS (ONLY FOR CR2B224S)

Disconnect the A/C from the main power box or
designated circuit breaker and turn off the range to
make sure that burners are off and cool before
removing burners and reflector bowls.

Remove the burners and reflector bowls as
follows:
1. Lift the edge of the unit opposite the receptacle,
just enough to clear the reflector bowl.
2. Pull the surface unit gently out of the mounting
receptacle.
3. After the unit has been removed, the reflector
bowl can be lifted out of its mounting.

Clean the burners and reflector bowls with mild detergent and warm water. Wring excess water out of
the sponge or cloth when cleaning them.

Replace the burners and reflector bowls as follows:
1. Line up the opening of the reflector bowl with the burner
’s receptacle, hold the surface unit as level
as possible with the terminal just positioned into the receptacle, then push the surface unit
’s
Surface Unit
Receptacle
Reflector Bowl