26
#
"
!
Edgebander
G 330 / G 360 / G 380
The machine has to be connected to a dust extractor.
Chip container–Radius scraping unit
A chip container for the long scraper unit shavings can
be added to the machine (optional equipment).
The scraper shavings are collected in a chip container.
The chip container must be emptied every so often, depen-
ding on the operating time.
The lid of the chip container must stay closed during normal
operation.
Open the lid once the extraction system is switched off
and remove the shavings.
!
Extraction port with diameter 120 mm
"
Scraper cuttings collection box (Optional)
#
2x extraction ports with diameter 80 mm
(G 360 / G
380)
Dust extraction port-Ø–Central
120 mm
Dust extraction port-Ø–Side Trimming Unit
(G 360 / G 380)
2x 80 mm
Air speed,
20 m/s
Volume flow,(New at Format-4 20 m/s)
815 m³/h
(G 330)
1500 m³/h
(G 360 / G 380)
7.6 Dust extraction port
The quality of the edgebanding, the good functioning and durability of the machine all depend on the
quality of the dust extraction system used.
Setup and installation
Fig. 7-4: dust extractors–
Central
Fig. 7-5: dust extractors–Side Trimming Unit
Requirements for the dust extraction system and hoses:
The dust extraction system must produce the required vacuum and air flow (see table).
Attention!
The dust extraction hose must be non-flammable and must not conduct electricity! For this reason, only use genu-
ine FELDER dust extraction hoses!
