11
Edgebander
G 330 / G 360 / G 380
2.8 Machine hazards
The machine has undergone a hazard analysis. The
design and construction of the machine are based on the
results of this analysis and correspond to state-of-the-art
technology.
The machine is considered operationally safe when used
properly.
Nevertheless, there are some remaining risks that must be
considered.
The machine runs at high electrical voltage.
Warning! Danger! Electric current! Electrical energy can cause serious bodily injury. Damaged insulation mate-
rials or defective individual components can cause a life-threatening electrical shock.
Safety
2.9 Other risks
Warning! Risk of injury! Even if the safety measures are complied with, there are still certain associated
risks that must be considered when working on the machine:
•
Before carrying out any maintenance, cleaning and
repair work, switch off the machine and ensure that it
can not be accidentally switched on again.
•
When carrying out any work on the electrical
equipment, ensure that the voltage supply is
completely isolated.
•
Do not remove any safety devices or alter them to
prevent them from functioning correctly.
•
Be wary of sharp edges to avoid cutting yourself, in
particular when changing the tooling.
•
Risk of injury if the operator comes into contact with
the rotating circular saw and/or spindle moulder
tools.
•
Risk of injury from workpieces or other workpiece
parts jamming in the machine or being ejected.
•
Risk of injury from workpiece kickback.
•
Hearing damage as a result of high noise levels
•
Health impairments due to the inhalation of airborne
particles, especially when working with beech and
oak wood.
• Risk of injury through being crushed, cut, caught,
wound up or sliced.
• Risk of burn injuries as a result of coming into contact
with heated mechanical parts. Always use appropri-
ate protective gear (e.g. gloves) and always be very
careful.
• It is strictly forbidden to climb onto the machine -
danger of falling.
