11
2 x
4 x
!
!
!
!
FAT 300 - ca. 75 kg
FAT 300S - ca. 175 kg
FAT 500S - ca. 220 kg
Height adjustable FELDER working table
FAT 300 / FAT 300S / FAT 500S
Fig. 4-1: Transport locking device
4.5 Transport
4.4 Storage
Keep items sealed in their packaging until they are
assembled/installed and be sure to observe the stacking and storage symbols on the outside of the packaging.
Store packed items only under the following conditions
• Do not store outdoors.
• Store in a dry and dust-free environment.
• Do not expose to aggressive substances.
• Protect from direct sunlight.
• Avoid subjecting the machine to shocks.
• Storage temperature: -10° to +50° C.
• Maximum humidity: 60 %.
• Avoid extreme temperature fluctuations (condensation
build-up).
• Apply a coat of oil to all bare machine parts (corrosi-
on protection).
• When storing for longer than 3 months, apply a coat
of oil to all bare machine parts (corrosion protection).
Regularly check the general condition of all parts and
the packaging. If necessary, refresh or re-apply the
coat of
anti-corrosive agent.
• If the machine is to be stored in a damp environment,
it must be sealed in air-tight packaging and protected
against corrosion (desiccant).
Transport, packaging and storage
FAT 300:
The machine is partly assembled when delivered on the
pallet
To facilitate assembly, ensure the presence of a minimum
of one additional people.
FAT 300S / FAT 500S:
The machine is completely assembled when delivered on
the pallet.
Attention!
Heavy dead weights can easily cause an
injury!
Depending on the equipment, two or three additional
helpers may be necessary when unloading.
The machine is shipped mounted on a pallet. (4 x Secu-
ring bolt)
The machine can be transported/unloaded with a fork
carriage or a forklift truck or with a crane and hoisting
loop.
!
Securing bolt
Note:
The transportation width is well under 1000 mm. This makes it possible to transport the machine through
doorways.
Individual installation instructions are found with the machine or the worktop surface.
Depending on the equipment, two or three additional helpers may be necessary when unloading.