Authentication Guide
BLE mode
Short press the button to power on and enter BLE mode. The authentication
indicator should start blinking.
Make sure this authenticator has been paired with the client. Any authentication
request received will be responded automatically within a limited time
(20 seconds) after powered on. Pressing the button to refresh the timer.
Using FIDO U2F with BLE mode on mobile devices requires middle ware.
Using Chrome browser and Google authenticator is a good example.
NFC mode
Make sure the device is off.
Request authentication from the client device.
Attach the key to the NFC sensor.
Using FIDO U2F with NFC mode on mobile devices requires middle ware.
Using Chrome browser and Google authenticator is a good example.
USB mode
Connect the authenticator with your client PC over the attached USB cable.
The authentication indicator blinks when an authentication request is received.
Press the button to confirm this authentication.
1.
2.
*
1.
2.
3.
*
1.
2.
3.
BLE Pairing Guide
Press and hold the button for 5 seconds till the BLE indicator is blinking, release
pressing. This authenticator keeps blinking for 15 seconds if there is not pairing
request received.
Scan BLE devices on your client side (e.g. a smart phone). Connect the BLE device
which has the same alphabetic name as printed on the back of the authenticator
(As example shown in the figure “ABCDEF”).
Input 6-digits PIN as printed on the back of the authenticator
(As example shown in the figure “123456”).
For security purpose, the authenticator will be forced to shut down 60 seconds
after powered on.
1.
2.
3.
*
Содержание ePass FIDO U2F
Страница 1: ......
