Installation
4
WWW.FEIT.COM
Please contact 1-866-326-BULB (2852) for further assistance.
Take out the support rod (BB)
from the bag.
1
Take out the balloon from the bag.
4
Once the tripod legs have been adjusted to the desired position,
tighten Hand Screw 1 to set into place. Loosen Hand Screw 2 and
pull up the support rod to adjust the height of the fixture.
Tighten Hand Screw 2 to set into place.
3
Insert the balloon (AA) onto the tripod and plug the toggle switch
of the balloon (AA) to the support rod (BB)
5
Now plug it into the main outlet and
turn it on by using the toggle switch
on the balloon (AA).
6
Loosen Hand Screw 1, then partially pull out the legs of the tripod
(see Fig. 1). Pull up to adjust the width of the legs of the tripod
(see Fig. 2).
2
AA
BB
Plug in the
connector
Tripod
Hand screw 2
Fig. 1
Fig. 2
BB
Hand screw 2
Hand screw 1
Tripod legs
Hand screw 2
Hand screw 2
Hand screw 1
Tripod legs
Hand screw 1
ON
OFF
