Fein Slugger JHM Magforce X, Инструкция по эксплуатации

Страница: 12 / 47

12
en
Changing the tool (figure 5).
When there is danger of fall-
ing down, secure the
machine using the provided safety strap;
especially when working aloft, on vertical
building elements or overhead.
In case of a
power failure or when the mains plug is
pulled, the magnetic holding power is not
maintained.
Before mounting or replacing
cutting tool or accessories,
pull the power plug. This pre-
ventive safety measure rules
out the danger of injuries through accidental
starting of the power tool.
Push the chip guard upward.
Loosen both screws of the tool holder using
the hex key.
Insert the pilot pin into the cutter.
Insert the cutter with the pilot pin into the
tool holder.
Tighten both screws of the tool holder onto
the flats on the cutting tool using the hex
key.
WARNING
WARNING
Chip guard
Tool holder
Hex key
Hex key
Pilot pin
Cutter
1.
2.
2.