IDENTIFICATION
QUICK START
ID CPR30+
QUICK START
Page 6 of 7
CE Konformitätserklärung
Hiermit erklärt FEIG ELECTRONIC GmbH, dass der
Funkanlagentyp
ID CPR30+
der Richtlinie
2014/53/EU entspricht.
Der vollständige Text der EU-Konformitätserklärung
ist unter der folgenden Internetadresse verfügbar:
https://www.feig.de/service/eu-
konformitaetserklaerungen/
CE Declaration of Conformity
Hereby FEIG ELECTRONIC GmbH declares that the radio
equipment type
ID CPR30+
is in compliance with directive
2014/53/EU.
The full text of the EU declaration of conformity is available
at the following internet address:
https://www.feig.de/en/service/eu-declarations-of-conformity/
UKCA Declaration of Conformity
Hereby FEIG ELECTRONIC GmbH declares that the radio equipment type
ID CPR30+
is in compliance with
directive No. 1206 Radio Equipment Regulations 2017.
The full text of the UKCA declaration of conformity is available at the following internet address:
https://www.feig.de/en/service/ukca-declarations-of-conformity/
Notice for USA and Canada:
FCC ID: PJMCPR30P
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Unauthorized modifications may void the authority granted under Federal communication Commission Rules permitting the operation
of this device.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
IC: 6633A-CPR30P
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Warning:
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.