OBID
i-scan
®
UHF
Installation
ID ISC.MRU102-PoE-LED
FEIG ELECTRONIC GmbH
Page 14 of 21
M30119-1e-ID-B.docx
5. Control and Display Elements
5.1. LED
The Reader’s LED can be configured through software.
Table 7: Default configuration of the LEDs
Abbreviation
Description
LED green
"RUN "
-
Turns on when the Reader is ready
LED red
„LABEL“
-
Turns on when a transponder is detected.
-
Flashes if RF-Warning (red – green alternating with 8Hz)
(Temperature alarm, short circuit on antenna output)
5.2. Additional LEDs
In addition to the Multi-Color LED which shows the general operating state the reader is equipped
with three bright LEDs (red, green, yellow). Each LED can be configured individual by the user.
Detailed information regarding the configuration of the LEDs can be found in the Application Note
N20212-0e-ID-E.pdf.
Table 8: Additional LEDs
LED number
Color
Description
LED 3
Green
Not assigned
LED 4
Red
Not assigned
LED 5
Yellow
Not assigned
5.3. Buzzer
Next to the optical signalers the ID ISC.MRU102-PoE-LED is equipped with an integrated Buzzer.
The Buzzer can be controlled by the user. The volume of the Buzzer can be configured by Soft-
ware command. Detailed information regarding the configuration of the Buzzer can be found in the
Application Note N20212-0e-ID-E.pdf.
