Feig Electronic OBID i-scan ID ISC.SPAD102, Руководство по установке

Страница: 26 / 32

OBID i - scan
®
Installation ID ISC.SPAD102
FEIG ELECTRONIC GmbH Page 26 of 32 M10414-1de-ID-B.doc
E
N
G
L
I
S
H
11.2.2 Ethernet-Interface (ID ISC.SPAD102-E)
The Reader has an integrated 10 / 100 base-T network port for an RJ-45. Connection has an au-
tomatic “Crossover Detection” according to the 100BASE-T Standard.
Figure 3: Connection Ethernet-Interface
With structured cabling CAT 5 cables should be used. This ensures a reliable operation at 10 Mbps
or 100 Mbps.
The prerequisite for using TCP/IP protocol is that each device has a unique address on the net-
work. All Readers have a factory set IP address. Interface parameter can be configured via soft-
ware protocol
Table 11-3: Standard factory configuration of the Ethernet connection
Network Address
IP-Address 192.168.10.10
Subnet-Mask 255.255.255.0
Port 10001
DHCP OFF
Note:
The reader provides a DHCP able TCP/IP interface.
It is recommended to use a shielded twisted pair STP CAT5 cable.