Feig Electronic OBID i-scan ID ISC.M02, Монтаж, установка

Страница: 35 / 42

OBID
®
Installation ID ISC.M02
FEIG ELECTRONIC GmbH Page 35 of 42 M20301-0de-ID-B.doc
E N
G
L I S H
8.4. Operating elements
8.4.1. Operating/Programming Mode: Jumper J1
Jumper J1 is used to configure the operating and programming mode of the ID ISC.M02.
In standard operation the jumper is set to Position 1-2 (see Fig. 4.3.1-1). The reader is then in
normal operating mode.
If the jumper is set to Position 2-3, the integrated hardware bootloader starts after a reset. Since
the reader’s firmware however also has a software bootloader, the hardware bootloader option
should be used only for installing the software bootloader.
For additional information about programming the reader, see the corresponding Application Note
„Firmware Update“.
Jumper position Mode
1 - 2
Standard setting :
The reader is in normal operating mode.
2 - 3
Activation of the hardware bootloader:
After a reset the reader’s CPU starts its hardware
bootloader, which can then be used for new pro-
gramming.
Table 3.4.1-1: Jumper J1
Bild 3.4.1-1: Jumper J1
J1
1
2
3
J2
J3
X2
X3
X4
Standard-
setting
X1
J1
V2 V1
C65
C73