Feig Electronic OBID i-scan ID ISC.DAT, Монтаж, установка

Страница: 30 / 44

OBID i-scan
®
Installation ID ISC.DAT
FEIG ELECTRONIC GmbH Page 30 of 44 M40401-4de-ID-B.doc
E N G L I S H
3.2.1 X1: Reader connection and supply voltage
The HF line and the supply voltage are connected as shown in Fig. 5 at SMA socket X1. The
dynamic antenna tuner operates on a DC voltage of 7 - 12V.
Fig. 5: HF line and supply voltage connection
The supply voltage of 7 –12 V
DC
is present as a DC voltage offset on the HF line. See also
5.3.1 Supply voltage .
3.2.2 X2: Boot Loader Interface
To perform a firmware update you have to connect the update cable ID CAB.RS-B with X2 as
shown in Fig. 6. The tuning board must be powered through the antenna cable on X1 as it is done
in the normal operation mode. See also
5.3.1 Supply voltage .
Fig. 6: Connection of the Update Cable
The procedure of the firmware update is described in Application Note ID ISC.DAT – Firmware
Update (N50801-xe-ID-B).
X1