OBID i-
scan
®
Installation
ID ISC.ANT1700/740-A /-B
FEIG ELECTRONIC GmbH
Page 7 of 74
M91201-5e-ID-B.doc
3
Performance Features of the ID ISC.ANT1700/740 Antennas
The ID ISC.ANT1700/740-A antenna is a version with DynamicTuning Board ID ISC.DAT , Long
Range Reader ID ISC.LRM2500-B, 4- times Multiplexer Module ID ISC.ANT.MUX M4 and
additional signal light and buzzer already mounted.
The ID ISC.ANT1700/740-B antenna is a version with DynamicTuning Board ID ISC.DAT and
signal light mounted.
Up to
-
two antennas with reader and multiplexer as a single gate,
-
three to four antennas with reader and multiplexer as a double gate or triple gate
-
up to 8 antennas as multiple gate with up to 7 aisle at the use of the 8-times Multiplexer
ID ISC.ANT-MUX M8.
can be operated.
Depending on the antenna configuration, one, two or all three read orientations of the Smart Tags
and various antenna spacing (gate widths) are possible.
The ID ISC.ANT1700/740-
A/B is a „figure-of-eight“ antenna with tuner and have been optimized as
transmitting and receiving antennas for the ID ISC.LRM2500 Reader. It is however also possible to
operate them with other Readers at a transmission frequency of 13.56 MHz and an output
impedance of 50
. The read ranges indicated in this document and the tuning procedures may
however then vary.
The antennas comprise the electrical antenna conductor, the housing, the ID ISC.DAT
Dynamic
Antenna Tuner
and the connection cable
.
The antennas are factory tuned to an impedance of 50
in a magnetically neutral environment at a distance of 95 cm. When installing in different ambient
conditions the antenna can be retuned using the “DATuningTool“ PC software. After tuning the
antennas will retain their settings as long as the ambient conditions remain unchanged.
The antennas can be used for detecting both product and persons. It is suitable for installation
indoors or outdoors if weather-protected
.
