OBID
®
classic-pro
Installation
ID CPR.03.20-CD
FEIG ELECTRONIC GmbH
Page 22 of 24
M60100-2de-ID-B.doc
E N G L I S H
4.3
Configuration
Configuration is carried out by means of a ConfigCard. An ISO 15693 transponder can be used as
ConfigCard (e.g.
Infineon my-d, SFR55V10P, Philips I-CODE SLI, etc.)
The configuration data are stored in a specified read/write data block on the transponder. The
transponder is also provided with identifiers which enable recognition as the ConfigCard.
The creation and modification of a ConfigCard could be done the FEConfigCardTool which is available for
Windows operating systems.
4.3.1 Default Configuration
The factory configuration of the reader is as follows:
•
Reads serial numbers (UID) of ISO 14443 type A, ISO 14443 type B and ISO 15693 trans-
ponders.
•
Data output: Bit 0 to 32 from UID in Wiegand format.
4.3.2 Reloading the configuration
1.
Switch on the power supply.
2.
Hold the ConfigCard in the reading range during the configuration phase (8 seconds). During
this time the red and green LEDs flash alternately.
3.
After the configuration is complete the reader automatically switches back to normal mode.
Signals:
The reader acknowledges a ConfigCard with the following signals:
1 x LED green + Beeper (1 s)
⇒
OK
ConfigCard has been processed, reader is operating with the new configuration
2 x LED rot + Beep
⇒
Fault
ConfigCard is not read correctly.
⇒
Repeat procedure.
⇒
Check the ConfigCard for correct programming.
Note:
ConfigCards with incorrect AFI are not recognized by the reader. No signaling is
possible
