IDENTIFICATION
ID ECCO Smart HF-BLE
Connection with WIN10 PC
USER GUIDE
Page 19 of 25
9.4 Connection by Bluetooth LE (BLE)
To connect the mobile reader ID ECCO Smart via BLE to a MS Windows (WIN 10) PC a FEIG USB Stick is
necessary.
1. If the I not available on your PC, see chapter
9.1 I Configuration and Test Tool
2. If the ECCO Smart is on, please switch it off.
3. Connect the USB Stick to your PC. Wait till Win 10 has recognized to stick. Windows will generate a new
virtual COM port for every new BLE.USB stick
4. If the ECCO Smart is off, please switch on
5. Start FEIG Tool I V11.01.00 or newer
6.
Click on the “Detect” button and the Re
ader Detection window will open
Fig. 10: Detect window if I
7. Communication interface: Select the COM port (e.g. 14, in many cases, the highest available port
number). Note: Every ID BLE.USB Dongle create a new vertical COM port at your PC
8.
Click on the “More” button in the window Communication Interface
, line COM-Port.
9.
Enable DTR and RTS in the “for Serial to TTL Converter” windows and close the
window.
Fig. 11: Window Additional Options for Serial Converter
10. C
lick on the “Detect” button in the window
. Note:
11. The Reader Detection window show the ID ECCO Smart HF-BLE and the actual firmware version.
12.
Click on button “Run without change”
and the Window for the detected reader will open
13. The use of the FEIG Tool ISOStart is described in H80301-e-ID-B.pdf.
