Danger! Risk of electric shock!
To ensure the machine remains weatherproof, before any use check to see that the switch, power
cable or plug are not damaged (no cracks, etc.)
Do not use the power cable for any purpose it is not intended for.
A device for automatic disconnection of the power supply must be installed by the user in the line
powering the machine to protect people against electrical shock due to indirect contact in the
machine.
Risk of personal injury and crushing by moving parts!
Do not operate the machine without installed guard.
Keep sufficient distance to driven components when operating the machine.
Ensure the machine is disconnected from power supply before servicing.
Ensure that when switching on (e.g. after servicing) no tools or loose parts are left on or in the
machine.
Turn power off if the machine is not used.
Hazard generated by modification of the machine or use of parts not tested and
approved by the equipment manufacturer!
Use only parts approved by the equipment manufacturer. This applies particularly to :
-
Saw blade (see “Technical specifications”)
-
ON/OFF switch (type: KOA7)
-
Motor
Do not change any parts.
Hazard generated by machine defects!
Keep machine and accessories in good repair. Observe the maintenance instructions.
Before any use check machine for possible damage: before operating the machine all safety
devices, protective guards or slightly damaged parts need to be checked for proper function as
specified. Checked to see that all moving parts work properly and do not jam. All parts must be
correctly installed and meet all conditions necessary for the proper operation of the machine.
Damaged protection devices or parts must be repaired or replaced by a qualified specialist. Have
damaged switches replaced by a service center. Do not use this machine if the switch can not be
turned ON or OFF.
Keep handles free of oil, grease and resin.
Hazard generated by dust
Pay attention to the factors that influence exposure to dust, this includes:
-
Type of material being machined
-
Importance of local extraction (capture at source)
-
Proper adjustment of hood / baffles / chutes
A. The machine should be checked whether inner and outer blade cover
、
left and right side table
moving cover
、
inner and outer flange of blade and blade are proper before operation.
B. Pushing the moving worktable forward and check whether left and right table moving cover and
inner and outer blade touch each other so as to avoid unnecessary damage, while the log saw is
working after turning-on the power.
C. Please turn off the power supply after using, cleaning the machine, save at dry airiness place.
Remove plug from mains before maintenance or if cord is damaged
06