Feider Machines FTDT5070, Инструкция по эксплуатации

Страница: 13 / 19

13
- Do not use a pressure washer or hot water to clean the mower. Be careful to avoid
soaking parts such as the engine, air cleaner, wheel bearings and metal fastenings.
Dry off the machine before storing by leaving it running for a few minutes on a flat,
clear surface to prevent corrosion or seizure.
b. Blade maintenance
WARNING: Wear gloves, turn off the engine and remove the spark plug before
proceeding.
The blade is made of hardened steel. To get a clean job, sharpen the blade frequently,
about every 25 hours of use. Make sure the blade is always well balanced.
Insert a small iron pin (2 or 3 mm in diameter) into the hole in the middle of the blade: it
must remain horizontal. If the blade does not stay horizontal, balance it by sharpening it
further on the side where it is leaning.
WARNING: Use only original spare parts. Poor quality replacement parts can cause
serious damage to your mower and affect your safety.
To remove the blade, loosen the screw, check the blade bracket, and replace all parts if
they are worn or damaged.
When reassembling the blade, make sure that the cutting edges are in the same direction
as the direction of rotation of the motor. The tightening torque of the blade screw should
be 3.7 kg * m / s 2 (37 Nm) and can be checked with a torque wrench.
c. Storing the mower
Store your mower in a dry, well
-
ventilated area, away from flames, sparks or heat
sources. If the storage area is accessible to children, immobilise the machine by
disconnecting the spark plug’s cap. Storing the mower beneath a tarpaulin or similar
cover is not recommended as it may cause a build
‐
up of condensation resulting in
corrosion of the mower.
Extended shutdown and winter storage
Thoroughly clean the mower. Ideally, run the engine outdoors until the fuel tank is empty.
Alternatively, empty any remaining fuel using a fuel suction pump.
Dispose of discarded fuel safely and responsibly, remembering that petrol vapours can
cause explosion or fire. Run the engine until any remaining fuel is consumed. Allow the
engine to cool. Check the condition and cleanliness of the air cleaner. Remove the spark
plug from the engine and pour a tablespoon of engine oil into the cylinder. Gently pull the
starter rope several times to turn over the engine, distributing the oil to protect the
cylinder over winter. Replace and tighten the spark plug.
At the start of the new season