EN
2) Hold the baseplate flat against the edge of the work piece and lift the body of the saw
until the blade is at the right depth determined by the depth of cut scale (20) (align the
scale line).
3) Tighten the lock lever for depth adjustment.
Angle adjustment (Fig. 6)
1) Loosen the Lock knob for angle adjustment (9).
2) Adjust the shoe to the desired angle between 0°to 45°. [See miter scale (8)].
3) Tighten the lock knob for angle adjustment.
Switching on and off(Fig.7)
Before engage the ON/OFF switch, check that the saw blade is properly fitted and run
smoothly, the blade clamp bolt is well tightened.
1) Connect the plug to the power supply
，
the power-on indicator (5) is illumed until the tool
disconnect from the power mains.
2) To switch on the circular saw, press the lock-off button (18) and pull the ON/OFF switch
trigger (17).
3) When you release the switch trigger (17), the tool turns off.
Parallel cut adjustment(Fig.8)
1) Loosen the lock knob of edge guide (10).
2) Slide the parallel guide (12) through the slots in the shoe to the desired width.
3) Tighten the lock bolt to fit it in the position.
4) Ensure that the edge guide rests against the wood along its entire length to give a
consistent parallel cuts.
Laser line generator ( Fig. 7)
,
Warnings:
Do not stare directly at the laser beam, do not deliberately aim the beam at
personnel and ensure that it is not directed towards the eye of a person for longer than 0.25s.
When you make the line of the cut on the work piece, the laser line generator can help you
get better alignment.
Turn on: Press the laser generator switch (4), the laser generator (7) works.
Turn off: Press the switch again.
1) Make sure line of the cut on the work piece.
2) Adjust the angle of cut as required
3) Plug in the machine and start the motor
4) When the blade is at its maximum speed (approximately 2 seconds), place the saw on the
work-piece.
5) Switch on the laser generator from the laser aperture using the laser generator switch (4).
13
